Computer Connection; Focuser Control With Sesto Senso Software - PrimaLuceLab SESTO SENSO Manual

P r i m a L u c e L a b i S r l
SESTO SENSO comes with a complete software (included in the USB pen)
that allows you to calibrate SESTO SENSO, move the focuser and set ad-
vanced parameters. After having connected SESTO SENSO to USB port of
your computer and powered it, please launch the SESTO SENSO software
and you will see the image you have here on the right.
SESTO SENSO software v. 2 shows, in the central part, different data like
the firmware version, serial number, temperature reading (if connected to
the opzionale temperature probe) and connection COM port. In the lower
part you can find the control and calibration buttons for and calibration of
SESTO SENSO. By clicking the arrow on the up-right part of the window,
you will see advanced parameters.
Please click on the grey window, select the COM port of SESTO SENSO (or
click on the symbol of the magnifier) and then click on "Open/Close" button.
If this is the first time you use SESTO SENSO, a Wizard window will popup
and, in a very easy way, this will allow you to correctly set SESTO SENSO for
your telescope.

Computer connection

At the first connection with the PC, SESTO SENSO is automatically detected as a
COM port (if SESTO SENSO is not automatically detected by Windows and you see
a new window asking for drivers, just select the driver in SESTO SENSO DRIVER
folder), just go to "Device manager" (click on Start button, then select System and
Control Panel, clock on System and then Device manager) and look at the COM port
number assigned, in the example here it's COM4. The status LED (detail 13) starts
blinking to confirm connection. If the LED lights up and remains still, power is lost
while the PC connection has been successfully performed.

Focuser control with SESTO SENSO software

p a g e ! 8
S E S T O S E N S O u s e r m a n u a l