Table of Contents
Advertisement
Cheetah 18 Installation Guide, Rev. A
Setting the SCSI ID jumpers
The SCSI ID for ST118202LC drives is normally set over the
SCSI bus by the host system. You can also use the J6 jumper
block to set the SCSI ID (see Figure 16).
Figure 16. Setting the SCSI ID on ST118202LC drives
LC drives section
Drive
Front
Jumper Plug
(enlarged to
show detail)
SCSI ID = 0
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
SCSI ID = 8
SCSI ID = 9
SCSI ID = 10
SCSI ID = 11
SCSI ID = 12
SCSI ID = 13
SCSI ID = 14
SCSI ID = 15
J6
LC drives
Pin 1
(default)
Note:
[1] Do not remove
cover from pins
13 through 20
(darkened area).
45
Advertisement
Table of Contents
