Table of Contents
Advertisement
46
LC drives
Terminating the drive
LC model drives do not have internal terminators or any other
way of adding internal termination to the drive. You must provide
external termination to these drives when termination is
required. Since this drive is designed to be plugged into a back-
panel or other host enclosure without cabling, this is normally
done by enabling termination on the backpanel or plane.
Note. Use active (ANSI SCSI-2 Alternative 2) single-ended ter-
minators when terminating a bus operating in single-
ended mode. Use SPI-2-compliant active low voltage dif-
ferential terminators when terminating a SCSI Ultra2 bus
operating in LVD mode.
Terminator power
ST118202LC drives cannot be configured to provide termination
power.
Cheetah 18 Installation Guide, Rev. A
Advertisement
Table of Contents
