Table of Contents
Advertisement
7.5.4.1
Shock
a. Operating—normal
The drive, as installed for normal operation, shall operate error free while subjected to intermittent shock not
exceeding:
• 40 Gs at a maximum duration of 11ms (half sinewave)
• 25 Gs at a maximum duration of 2ms (half sinewave)
Shock may be applied in the X, Y, or Z axis. Shock is not to be repeated more than once every 2 seconds.
b. Non-operating
The limits of non-operating shock shall apply to all conditions of handling and transportation. This includes
both isolated drives and integrated drives.
The drive subjected to nonrepetitive shock not exceeding the three values below, shall not exhibit device
damage or performance degradation.
• 80 Gs at a maximum duration of 11ms (half sinewave)
• 400 Gs at a maximum duration of 2ms (half sinewave)
• 300 Gs at a maximum duration of 0.5ms (half sinewave)
Shock may be applied in the X, Y, or Z axis.
c. Packaged
Seagate finished drive bulk packs are designed and tested to meet or exceed applicable ISTA and ASTM
standards. Volume finished drives will be shipped from Seagate factories on pallets to minimize freight
costs and ease material handling. Seagate finished drive bulk packs may be shipped individually. For less
than full shipments, instructions are printed on the bulk pack carton for minimum drive quantities and proper
drive placement.
Figure 14.
Recommended mounting
Note.
Image is for reference only, may not represent actual drive.
40
Savvio 10K.5 SAS Product Manual, Rev. D
Advertisement
Table of Contents
