Crosley XBS360 Owner's Manual page 19

Cleaning the Range – Exterior (Cont.)
Porcelain Enamel Cooktop
The porcelain enamel finish is sturdy but breakable if
misused . This finish is acid-resistant . However, any
acidic foods spilled (such as fruit juices, tomato or
vinegar) should not be permitted to remain on the finish.
If acids spill on the cooktop while it is hot, use a dry paper
towel or cloth to wipe it up right away . When the surface
has cooled, wash with soap and water . Rinse well .
Surface Units
WARNING
■ Be sure the controls are turned to OFF and the surface
units are cool before attempting to remove them .
■ Do not immerse the surface units in liquids of any kind .
■ Do not clean the surface units in a dishwasher .
■ Do not bend the surface unit plug terminals .
■ Do not attempt to clean, adjust or in any way repair
the plug-in receptacle .
■ Do not pull on the SENSI-TEMP TECHNOLOGY
sensor cap .
To clean the surface units, turn the control to the highest
setting for a minute . The coils will burn off any soil . To
clean the Sensi-Temp Technology Sensor cap, wipe
with a damp sponge or cloth . For cooked-on food spills,
remove the burner from the range and gently scrub the
cap and supports with a damp plastic scouring pad . Do
not use steel wool . Allow the burner to dry over night
before re-installing it .
To remove a surface unit:
To remove the drip pans for cleaning, the surface units
must be removed first .
1 . Push the surface unit back toward the receptacle .
2 . Lift the surface unit about 1 inch above the drip pan
and pull it out .
Do not lift the surface unit more than 1 inch . If you do, it
may not lie flat on the drip pan when you plug it back in .
NOTE: Repeated lifting of the surface unit more than
1 inch above the drip pan can permanently damage the
receptacle .
To replace a surface unit:
1 . Replace the drip pan into the recess in the cooktop .
Make sure the opening in the pan lines up with the
receptacle .
2 . Insert the terminals of the surface unit through the
opening in the drip pan and into the receptacle .
3 . Push the surface unit in and down so it rests evenly in
the cooktop .
49-2000226 Rev. 0
For other spills such as fat spatterings, wash with soap
and water or cleansing powders after the surface has
cooled . Rinse well . Polish with a dry cloth .
When properly seated, the locking tab should lock onto
the cooktop rim through the notch in the drip pan .
Surface Unit
Receptacle
Surface Unit
Drip Pan
Locking Tab
Cooktop Rim
Locking
Tab
Drip Pan
Locking Tab
19