Power Supply Backplane - HP PROLIANT ML350 G6 Maintenance And Service Manual

Select the Advanced Options menu.
2.
Select Service Options.
3.
Select Serial Number. The following warnings appear:
4.
WARNING! WARNING! WARNING! The serial number is loaded into the system during
the manufacturing process and should NOT be modified. This option should only
be used by qualified service personnel. This value should always match the
serial number sticker located on the chassis.
Warning: The serial number should ONLY be modified by qualified personnel.
This value should always match the serial number located on the chassis.
Press the Enter key to clear the warning.
5.
Enter the serial number and press the Enter key.
6.
Select Product ID. The following warning appears:
7.
Warning: The Product ID should ONLY be modified by qualified personnel. This
value should always match the Product ID on the chassis.
Enter the product ID and press the Enter key.
8.
Press the Esc key to close the menu.
9.
Press the Esc key to exit RBSU.
10.
Press the F10 key to confirm exiting RBSU. The server automatically reboots.
11.

Power supply backplane

To remove the component:
Power down the server (on page 27).
1.
Remove the power supplies
2.
Do one of the following:
3.
Unlock and remove the bezel
o
Extend the server from the rack.
o
Remove the access panel
4.
Remove the large redundant fan air baffle
5.
Remove the DIMM baffles
6.
Remove all fans ("Fan" on page 34).
7.
Remove all expansion boards
8.
Remove the system board
9.
For this procedure, removing the processors, heatsinks, DIMMs, and cache module from the system
board is not required.
Disconnect the cables from the power supply backplane.
10.
All manuals and user guides at all-guides.com
("Hot-plug power
("Front bezel" on page 29).
("Access panel" on page 30).
("Large redundant fan air
("DIMM baffle" on page 33).
("Expansion board" on page 44).
("System board" on page 64).
supply" on page 36).
baffle" on page 32).
Removal and replacement procedures 72