Drive Mounting; Figure 6. Mounting Dimensions-Top, Side And End View - Seagate CONSTELLATION.2 ST91000640NS Product Manual

Serial ata drive standard and self-encrypting drive models, sed fips 140-2 models
Hide thumbs Also See for CONSTELLATION.2 ST91000640NS:
Table of Contents

Advertisement

4.4

Drive mounting

You can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the
bottom-mounting holes. See Figure 6 for drive mounting dimensions. Follow these important mounting precau-
tions when mounting the drive:
• Allow a minimum clearance of 0.030 in (0.76 mm) around the entire perimeter of the drive for cooling as a
guideline. Please refer to Section 4.5 for final cooling requirements.
• Use only M3 x 0.5 metric mounting screws.
• Four (4) threads (0.080 in) minimum screw engagement recommended. Also ensure maximum screw length
does not bottom out in mounting holes.
• Do not overtighten the mounting screws (maximum torque: 4.5 in-lb, ± 0.45 in-lb).
Figure 6. Mounting dimensions—top, side and end view
Constellation.2 Serial ATA Product Manual, Rev. B
27

Advertisement

Table of Contents
loading

Table of Contents