Technical Service - TECNOEKA EKF 1021 UD Use And Instruction Manual

Electric Oven rev. 6 ______________________________________________________EKF 1021 UD – EKF 621 UD

1. Technical service

A technical check-up once or twice a year helps prolong the life of the appliance and
guarantees better operation.
Make sure that assistance is carried out solely and exclusively by qualified personnel.
For any spare parts orders or for any information about the appliance, always mention the serial
number and model (data indicated on the "technical data" plate at the rear of the oven).
2. General warnings
Very important!: keep this instruction book together with the appliance for future consultation.
These warnings were drafted for your safety and for that of others. Please read them carefully
before installing or using the appliance:
- If, on receipt of the goods, the packaging is damaged, write the following on the delivery
note: "I REVERSE THE RIGHT TO CONTROL THE GOODS", specify the damage and get
the driver to sign in acceptance; send a claim in writing to the seller within 4 calendar
days from the date of receipt. No claim shall be accepted after such period.
- The appliance is intended for professional use and must be utilised by qualified personnel
trained to use it.
- Any modification which may be necessary on the electrical system to enable installation
of the appliance, must be carried out solely by competent personnel.
- It is dangerous to modify or attempt to modify the characteristics of this appliance.
- Never clean the appliance with direct water jets, because, if any water enters, it could
limit the machine's safety .
- Before doing any maintenance or cleaning jobs, disconnect the appliance from the
electrical mains and allow it to cool.
- Do not attempt to carry out the periodic controls or any repairs by yourself. Contact the
nearest Service Centre and use only original spare parts.
N.B.: Improper or incorrect use and failure to observe the installation instructions shall release
the manufacture from all responsibility. In this connection, the directives in the "POSITIONING"
paragraph must be strictly observed.
3. Technical specifications
Modd.
Dimensions of appliance LxDxH(mm)
Weight (Kg)
Tray maximal load: GN2/1 (Kg)
Total load trays: GN 2/1 (Kg)
Max. absorbed power (kW)
Convection heating element (kW)
Power supply voltage (V)
Power cable diameter
Type of cable
Connecting electric cable
Class
Degree of protection against humidity
Water pressure
The noise level of the appliance in operation is below 70 dB (A).
The "technical data" plate is positioned on the rear panel of the appliance.
_________________________________________________________________________________________ page 5
(kPa)
EKF 621 UD
995x995x899
131
8
48
18,3
9
AC 400V 3N (50Hz)
2
5x4 mm
H07RN-F
Tipo Y
I
IPX3
100-200
EKF 1021 UD
995x995x1210
168
60
27,7
2
5x10 mm