M1100/M1120
Start Here
IMPORTANT: Before using this product, make sure you read these
instructions and the safety instructions in the online User's Guide.
Note:
The illustrations show the M1120, but the steps are the same for
both models, unless otherwise specified.
1
Unpack
Note:
Do not open either of the ink bottles until you are ready to fill the
ink tank. The ink bottles are vacuum packed to maintain reliability.
1
Remove all protective materials from the product.
Caution:
Do not touch the flat, white cable or the translucent
film inside the printer.
2
Close the printer cover.
Note:
Do not turn on the product yet.
2
Fill ink tank and charge
the ink
Warning:
Keep the ink bottles out of the reach of children and do not
drink the ink.
Caution:
This product requires careful handling of ink. If ink spills,
wipe it off immediately with a damp towel to avoid permanent stains. If
ink gets on your clothes or belongings, it may not come off.
Note:
• Epson cannot guarantee the quality or reliability of non-genuine ink.
• Use one of the ink bottles included with the printer to set up the
product. Part of the ink will be used to charge the print head. This
bottle may print fewer pages compared with subsequent ink bottles.
1
Connect the power cord to the back of the product and
to an electrical outlet.
Caution:
Do not connect to your computer yet.
2
Press the
power button to turn on the product, then
wait for the
power light to stop flashing.
3
Open the printer cover.
4
Press and hold the
ink and
power lights start to flash.
5
When the
ink light stops flashing, make sure the ink
tank is in the ink filling position and aligned with the
mark.
6
Open the ink tank cap.
ink button for 5 seconds until the