Greenheck MSXX04 Series Installation Instructions

®
These instructions apply to the external field installation of the Honeywell actuators on Greenheck models VCD Control
Dampers when they are duct mounted or sleeved.
These models are direct drive actuators that rotate to their energized position when power is applied, and spring return
to their fail position when power is disconnected.
Tools Required:
Wrenches: (1)
(1) Ratchet with
(1) 1 ⁄
Figure 1: Honeywell MSXX04 & MSXX09 Series external mount (exploded view).
6
WARNING
! !
Equipment Damage or Electrical Power Hazard. Line voltage can cause death or serious injury and short equipment
circuitry. Disconnect power supply before installation.
CAUTION
! !
Device Malfunction Hazard. Improper set screw tightening causes device malfunction. Tighten set screws with
proper torque to prevent damper shaft slippage.
INSTALLATION INSTRUCTIONS
⁄ in., (1) ⁄ in.
7 3
16 8
⁄ in. deepwell socket
3
8
in. Allen wrench
8
1
3
2
4
Document Number 477252
MSXX04 & MSXX09 Series Actuators
Part No.
1
2
3
4
5
6
7
8
9
5
7
4
With Jackshaft
Quantitiy Description
1 External Mounting Bracket
1 #10-24 x .375 Shoulder Bolt
1 #10-24 Nut
8 1/4 - 20 x 1/2 Spinlock Bolt
8 1/4-20 Spinlock Nut
1 Actuator
1 Standoff Bracket
1 Extension Pin - 5 3/4 in. long
1 Retaining Clip - 1/2 in. dia.
5
Note:
Actuator shaft collar
accepts 1/2 in. (13mm)
diameter shaft.
Without Jackshaft
8
9