Clearance Requirements - Cisco Nexus 9336C-FX2 Hardware Installation Manual

Clearance Requirements

Warning
Statement 1048—Rack Stabilization
Stability hazard. The rack stabilizing mechanism must be in place, or the rack must be bolted to the floor
before you slide the unit out for servicing. Failure to stabilize the rack can cause the rack to tip over.
Clearance Requirements
You must provide the chassis with adequate clearance between the chassis and any other rack, device, or
structure so that you can properly install the chassis, route cables, provide airflow, and maintain the switch.
For the clearances required for an installation of this chassis in a four-post rack, see the following figure.
1
2
3
4
Note Both the front and rear of the chassis must be open to both aisles for airflow.
Cisco Nexus 9336C-FX2 NX-OS Mode Switch Hardware Installation Guide
10
Chassis
Vertical rack-mount posts and rails
Chassis width
Width of the front clearance area (this equals the
width of the chassis with two rack-mount
brackets attached to it)
5 Depth of the chassis
6 Maximum extension of the bottom-support rails
7 Depth of the front clearance area (this equals the
depth of the chassis)
Preparing the Site