Integrated Electrical Socket; Standby Mode; Connecting The Dlan Pro 1200 - Devolo dLAN pro 1200+ Manual

3.3.4 Integrated electrical socket

If you connect additional network devices using a mul-
tiple socket, plug this multiple socket into the electrical
socket of the dLAN pro 1200+. The integrated mains
filter eliminates any noise of connected devices and si-
gnificantly improves data transmission in the home
network.

3.3.5 Standby mode

A dLAN pro device switches to Standby mode after a
short while if no active network device such as a com-
puter is connected to the network port. In Standby
mode, the dLAN pro device cannot be accessed
via the power supply grid. As soon as the network
device (e.g. computer) connected to the network inter-
face is switched on again, your dLAN pro device can
also be reached again via the electrical wiring.
If you would like to ensure that a dLAN pro device
does not switch to energy saving mode, this func-
tion can be deactivated in the dLAN AVpro manager
software. More information concerning "energy saving
mode" can be found in the chapter 2.2 devolo—Up
to speed on green IT.
3.4 Connecting the
dLAN pro 1200+
This section describes how to connect your
dLAN pro 1200+ to a computer or another network
device.
For the permitted voltage range for
operating the device and the power
consumption, refer to the label on
the rear side
Additional technical information is
available in the download area at
www.devolo.com.
Use the included network cable to connect the
dLAN pro 1200+ to the network port of your run-
ning computer or another network device.
Prevent tripping hazards when ca-
bling.
Plug the dLAN pro 1200+ into a free electrical
outlet.
devolo dLAN pro 1200+
Installation 17
of the device.