Setup; Ac Power; Fuse Replacement - Chauvet DJ GigBAR 2 User Manual

3. S
ETUP

AC Power

Fuse
Replacement
GigBAR 2 User Manual Rev. 7
The GigBAR 2 has an internal auto-ranging power supply and it can work with an input voltage
range of 100 to 240 VAC, 50/60 Hz.
To determine the product's power requirements (circuit breaker, power outlet, and wiring), use
the current value listed on the label affixed to the product's back panel, or refer to
Specificationsin this manual. The listed current rating indicates the product's average current
draw under normal conditions.
• Always connect the product to a protected circuit (circuit breaker or fuse). Make
sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
To eliminate wear and improve its lifespan, during periods of non-use completely
•
disconnect from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
Disconnect the product from power.
Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
Pry the fuse holder out of the housing.
Remove the blown fuse from the holder.
Replace with a fuse of the exact same type and rating.
Insert the fuse holder back in place and reconnect power.
Disconnect the product from power before replacing the fuse.
Spare fuse holder
(inside safety cap)
The product does not ship with a spare fuse; however, the safety cap has room for a spare.
Always replace a blown fuse with a fuse of the same type and rating.
Installed fuse
(held by plastic clip)
Safety cap
Technical
Page 19 of 156