Assembly Instructions - Schumacher PS-2352 Instruction Manual

L.
Wheel Charger Assembly Instructions:
NOTE: Charger must be assembled before operating
Parts Tools Necessary
(2)10-32 screws 5/16" wrench
(2) 1/4-20 screws 3/8" wrench
(2) wheels Hammer
(2) axle caps Screwdriver
(1) handle
(1) mounting foot
(1) axle
(2) axle brackets
1. First place the charger on it side.
2. Next mount the mounting foot FIG. A with (2) 1/4-20 screws,
or FIG. F with (2) 10-32 screws. Then, mount the (2) axle
brackets with the (2) 10-32 screws (as shown in FIG. D).
3. Next pound the axle firmly into an axle cap using a hammer
FIG. B.
4. Slide one wheel onto the axle with hub facing in, as shown
in FIG. C.
5. Poke above assembly axel brackets in charger back until
axle sticks out of the other end.
6. Turn charger on its other side.
7. Slide wheel and pound cap onto the axle end.
8. Next turn the charger right side up onto its foot and wheels.
9. Remove the (2) top screws from each side of the charger,
line up the handle and reinstall the screws FIG. E.

ASSEMBLY INSTRUCTIONS

9
HUBS MUST
FACE IN
Fig. C
Fig. A
AXLE BRACKET
Fig. D
Fig. F
Fig. B
AXLE CAP
Fig. E