Supermicro 2029P-TXRT User Manual page 52

SuperServer 2029P-TXRT User's Manual
NC-SI Header for IPMI Support
A Network-Controller Sideband Interface (NC-SI) header is located at JNCSI1 on the
motherboard. Connect an appropriate cable from this header to an add-on card to provide the
out-of-band (sideband) connection between the onboard Baseboard Management Controller
(BMC) and a Network Interface Controller (NIC) for remote management. For the network
sideband interface to work properly, you will need to use a NIC add-on card that supports
NC-SI and also need to have a special cable. Please contact Supermicro at
com to purchase the cable for this header. Refer to the table below for pin definitions.
Inlet Sensor Header
This header (JSEN1) allows BMC to monitor thermal inlet temperature. A special module is
required. Please contact Supermicro at
header. Refer to the table below for pin definitions.
NC-SI Header for IPMI Support
Pin Definitions
Pin# Definition
1 CLK_50MHz
3 NCSI_CRS_DV
5 NCSI_RXD0
7 NCSI_RXD1
9 NCSI_TXD0
11 NCSI_TXD1
13 NCSI_TX_EX
15 NC
17 5V STBY
19 5V STBY
21 5V STBY
www.supermicro.com
Inlet Sensor Header
Pin Definitions
Pin# Definition
1 SMBDAT
2 Ground
3 SMBCLK
4 3.3V STBY
52
Pin# Definition
2 Ground
4 Ground
6 Ground
8 Ground
10 Ground
12 Ground
14 NCSI_PRESENT_N
16 NC
18 5V STBY
20 5V STBY
22 NC
to purchase the module for this
www.supermicro.