Table of Contents
Advertisement
Page 28
F. Reinstall the bottom Finger Clusters (removed
in Step 2-B) using the original hardware.
Reinstall the original Fuses, Fuse mountings,
and associated hardware (removed in Step 2-
B) on the bottom Breaker Stabs. Refer to the
ITE K-1600 / 2000 Instruction Manual, originally
supplied with the Breaker for more information.
G. Rotate the Secondary Contact Bracket to its
original position (loosened in Step 2-A).
Secure it by reinstalling the original top screws
and tightening the bottom screws.
ATTENTION: Before proceeding, it is necessary
to verify which Step 12 is to be
followed for correct installation of
the Sensors. This is done by refer-
ring to the Icon(s) with each step.
STEP 12: INSTALLING THE SENSORS
Fig. 53 Overview – Installed Bottom Mounted
Sensor
A. Drill two .266" diameter holes in each side of
the rear Breaker Frame (See Drilling Plan "C").
0.266" DIA. HOLES
Fig. 54 Drilling Plan "C"
IL 33-K2C-3
0.56"
1.25"
5.44"
Effective 10/00
Advertisement
Table of Contents
