Table of Contents
Advertisement
Check the Wireless Network Setup/
Status
Follow these instructions when you can't establish
the wireless network connection.
a
Under "Network" settings screen as shown
below, touch "WLAN Status".
The wireless network connection status, protocol,
signal strength and Network Name (SSID) are
displayed.
a
b
c
d
a Displays the connection status.
When "Active (xxx)" is indicated:
The machine is connected to a wireless
network. The characters within the parentheses
indicate the protocol of the wireless network
being used.
When "Connection Fail: Err-xx" is indicated:
The machine failed to establish a connection.
"Err-xx" indicates the error number. See "Error
codes/Error messages" on page 13.
b Displays the wireless signal strength;
communication speed and channel being used.
c Displays the Network Name (SSID).
d Displays the communication mode. The
communication mode is fixed to the
infrastructure mode.
Using the "Others" Menu
The "Others" menu is at the bottom of the network
settings screen.
The "Others" menu contains the following items.
a
b
c
d
a TCP/IP can be manually entered.
b Displays the MAC address.
c All applied network settings will be reset to
manufacturers original settings when the
machine was purchased. Any information you
inputted will be removed (erased). After setting
this function, turn the machine off, then on
again.
d Use this when proxy settings are required.
9
Advertisement
Table of Contents
