Page of 13

Stiga SILENT 45 COMBI User Manual

Stiga lawn mower user manual.
Hide thumbs
4 5 C O M B I
4 5 S C O M B I


   Related Manuals for Stiga SILENT 45 COMBI

   Summary of Contents for Stiga SILENT 45 COMBI

  • Page 1

    STIG A S ILE N T 4 5 C O M B I 4 5 S C O M B I 8211-3442-07...

  • Page 2: Assembly, Remove The Oil Dipstick

    SVENSKA 6. LS45 7. ES45 FULL 0,15 l.

  • Page 3: Press Down Primer Fully, Protective Grille

    8. LS45 14. ES45 SVENSKA 9. ES45 13. LS45 15. LS45...

  • Page 4: Refit The Key, Remove The Air Cleaner/cartridge

    16. ES45 19. LS45 0,75 mm SVENSKA 17. Left 20. ES45 18. Right...

  • Page 5: Adjusting The Clutch Cable, Changing Blades

    45 Nm SVENSKA...

  • Page 6


  • Page 7: Using The Mower

    SYMBOLS The following symbols are displayed on the ma- chine in order to remind you about the safety pre- cautions and attention necessary when using the machine. The symbols mean: Warning! Read the Instruction Book and Safety Manual before using the machine. Warning! Keep spectators away.

  • Page 8: Starting The Engine, Before Starting

    2. COLLECTION Assemble the enclosed grass collector (fig. 5). Open the cover, remove the plug and this time hook the collector in place onto the back of the ma- chine. During cutting, the grass is collected in the collec- tor. Empty the grass on the compost heap or spread it out on the flower bead as fertilizer.

  • Page 9: Rear Wheel Drive, Cutting Height, Cooling System

    2. If the lawn mower is left unattended to, remove the lead from the spark plug. Also remove the starter key (*). If the start/stop loop no longer works, stop the engine by removing the lead from the spark plug. Immediately take the lawn mower to an authorised work- shop for repairs.

  • Page 10: Changing Oil, Air Filter

    CHANGING OIL Replace the oil when the engine is warm and the fuel tank is empty. Take care while draining as the oil is hot, this is to prevent burns. Change the oil the first time after 5 hours of oper- ation, and subsequently after every 50 hours of op- eration or once a season.

  • Page 11: Winter Storage

    To change blades, loosen the blade bolt. Mount the new blade so that it sits in the same way as the old one and tighten the blade bolt (fig. 26). Tightening torque: 45 Nm. When replacing the blade, the blade bolt should also be replaced.

  • Page 12


  • Page 13

    M O W I N G A H E A D G G P S w e d en A B · B ox 1 00 6 · S E- 5 73 28 T R A N Å S w w w. s t i g a . c o m...

This manual also for:

45s, 45se, Silent 45 s combi, Silent 45 combi

Comments to this Manuals

Symbols: 0
Latest comments: