11 Securing screws fo r sealed-beam
unit retaining ring. Loosen secur
ing screws, remove retaining ring
and unit. Pull off connector.
12 Securing screws fo r fog lamp
retaining ring. Loosen securing
screws and take out lamp body.
Pull o ff plug (13). Disengage
retaining spring and remove
bulb (14).
15 Bulb fo r turn signal, parking, side
marker and standing lamp.
Loosen fastener (6). Push lamp
body forward and detach. Hold
lamp holder by the wide lug and
pull out. Depress bulb, turn to the
left and take out. When installing
the bulb holder, the lugs m ust
engage the lamp body recesses.
When installing the lamp body,
never fail to engage the locating
webs (16) between the retaining
springs (17).
Electrical System
Tail Lamp Assembly
Remove both knurled nuts in the
tru n k and pull off lens assembly. To
replace the bulbs, depress, turn left
and pull out.
1
Turn signal lamp (21 W /32 cp)
side marker lamp (4 W /2 cp)
2
Tail, parking and standing lamp
(10 W /6 cp)
3
S top lamp (21 W /32 cp)
4
Backup lamp (21 W /32 cp)
69