Rollerdor RD55 User Manual

Rollerdor RD55 User Manual

Roller garage doors
Hide thumbs Also See for RD55:

Advertisement

User Guide
Rollerdor RD55 and RD77 Roller Garage Doors

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RD55 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Rollerdor RD55

  • Page 1 User Guide Rollerdor RD55 and RD77 Roller Garage Doors...
  • Page 2: Remote Control Unit

    REMOTE CONTROL UNIT (HOLD TO RUN) OPERATION BY HANDSET To open the roller garage door, press and release the top left (triangle) button on the remote control handset and the door will travel to its top limit. To close the roller garage door, press and hold the top right (triangle) button on the remote control handset and the door will travel all the way to its bottom limit, if there is something or someone in the way then release the...
  • Page 3: Battery Replacement

    Rollerdor RD55 and RD77 Roller Garage Door User Guide PROGRAMMING REMOTE CONTROL HANDSETS AND PUSH BUTTON (HOLD TO RUN) Slide the white cover down on the remote control handset and you will see there are four buttons (fig 2.1). Press and hold the top right button ( ), if the door moves then the handset is already programmed in.
  • Page 4 REMOTE CONTROL UNIT (HOLD TO RUN) OPERATION BY HANDSET To open the roller garage door, press and release the left (triangle) button on the remote control handset and the door will travel to its top limit. To close the roller garage door, press and hold the right (triangle) button on the remote control handset and the door will travel all the way to its bottom limit, if there is something or someone in the way then release the button...
  • Page 5 Rollerdor RD55 and RD77 Roller Garage Door User Guide PROGRAMMING REMOTE CONTROL HANDSETS Slide the black cover down on the remote control handset and you will reveal four buttons (fig.2.1) Press and hold the left button ( ), then press and...
  • Page 6: Sequential Operation

    REMOTE CONTROL UNIT (SAFETY EDGE) SEQUENTIAL OPERATION AND INDEPENDENT BUTTON OPERATION) SEQUENTIAL OPERATION To operate the roller garage door use the top button on the remote control handset ONLY! This will open the door if closed and close the door if open. Please note: When opening the door in normal use, or if the safety edge is activated, the curtain will need to travel all the way to the top before it will close again.
  • Page 7: Operation By Push Button

    Rollerdor RD55 and RD77 Roller Garage Door User Guide OPERATION BY WIRELESS KEY PAD To operate the roller garage door, enter the access code and press OK, the LED will issue a green light for 2 seconds then the door will travel to its top or bottom limit.
  • Page 8 PROGRAMMING OF REMOTE CONTROL HANDSETS AND PUSH BUTTON (SAFETY EDGE) SEQUENTIAL OPERATION Press and hold the “RADIO PROG” button (fig. 10.1). You will hear a beep and the red LED alongside “C1” will illuminated. Then release the “RADIO PROG” button. Press top button on handset (fig.10.2A).
  • Page 9: Installation

    Rollerdor RD55 and RD77 Roller Garage Door User Guide WIRELESS PUSH BUTTON (ONLY AVAILABLE WITH SAFETY EDGE SYSTEM) INSTALLATION Push Button (fig.6.1) Fit directly to the wall using the 2 fixings making sure it is level and square with the writing at the top.
  • Page 10: Wireless Key Pad

    WIRELESS KEY PAD (ONLY AVAILABLE WITH SAFETY EDGE SYSTEM) INSTALLATION Fit directly to the wall using the 2 fixings making sure it is level and square with the writing at the bottom. PROGRAMMING CODES Access Code Master Code: Press and hold the * button (fig.7.1a). for 3 Press and hold the * button (fig.7.1a) seconds until the LED issues a slow red...
  • Page 11 Rollerdor RD55 and RD77 Roller Garage Door User Guide CLEARING MEMORY OF REMOTE CONTROL HANDSETS (SAFETY EDGE) Press and hold the “RADIO PROG” button (fig.8.1). You will hear a beep and the red LED alongside “C1” will illuminate. Insert screwdriver between the 2 pin terminals on the board (MR) to bridge between them (fig.8.1).
  • Page 12: Use And Operation

    REMOTE CONTROL UNIT (SOMFY SAFETY EDGE) USE AND OPERATION NORMAL OPERATION Operation with a 2 or 4-button remote control Press the programmed button to operate the door. STOP STOP STOP OBSTACLE DETECTION OPERATION During closing, the detection of an obstacle causes the door to stop and re-open partially. The receiver warning light flashes rapidly to indicate that the door has encountered an obstacle.
  • Page 13 Rollerdor RD55 and RD77 Roller Garage Door User Guide OPERATION WITH THE ALARM The alarm is triggered for 2 minutes if the door is raised manually. No movement of the door is possible when the alarm is sounding. When the alarm sounds, press a button on a remote control memorised in the receiver to stop it. The alarm can only be stopped with a memorised remote control.
  • Page 14: Replacing The Remote Control Battery

    MAINTENANCE REPLACING THE REMOTE CONTROL BATTERY [1]. Remove the integrated light bulb. [2]. Replace the E14 - 25W - 230V type bulb. CHECKING THE OBSTACLE DETECTION OPERATION Only use an AA 3V6 lithium battery (Somfy part number 1782078). AA 1V5 alkaline batteries are not compatible. 3 screws 3 vis Remove and replace the 4 used batteries with...
  • Page 15: Technical Specifications

    Rollerdor RD55 and RD77 Roller Garage Door User Guide REPLACING THE INTEGRATED LIGHT BULB [1]. Remove the integrated light bulb. [2]. Replace the E14 - 25W - 230V type bulb. CHECKING THE OBSTACLE DETECTION OPERATION Every 6 months, check that the door reverses its movement when it encounters an object which is at least 40 mm high on the ground.
  • Page 16: Operating Diagnostics

    OPERATING DIAGNOSTICS The indicator lights on the front of the Rollixo receiver notify the user of the installation’s status.
  • Page 17 (According to 89/106/EEC Directive, Annex III.2(ii),second possibility) Rollerdor Ltd 10 & 12 Jarrold Way, Bowthorpe Employment Area, Norwich, Norfolk NR5 9JD Hereby declares that Roller garage doors series RD55 & RD77 Applied directives and harmonized standard: EN 13241-1:2003+ A1:2011 Industrial, commercial and garage doors and gates – Product standard –...
  • Page 18: Maintenance

    MAINTENANCE Your new roller garage door is designed to be as low maintenance as is possible, but there are some measures that you should take to keep the door working and prolong the life of your roller garage door. Always check to make sure there are no obstructions when operating your roller garage door and watch the door close and open fully.
  • Page 19 Rollerdor RD55 and RD77 Roller Garage Door User Guide TROUBLESHOOTING I have pressed the button Check to make sure there are no obstructions in the way of the curtain on my handset and the and that the guide runners are clear of debris and have not been door started to close but damaged or dented.
  • Page 20 Rollerdor Ltd 10 Jarrold Way Bowthorpe Employment Area Norwich Norfolk NR5 9JD +44 (0)1603 743215 colin@rollerdor.net www.rollerdor.net Company Registration Number. 10676267...

This manual is also suitable for:

Rd77

Table of Contents