Table of Contents
Advertisement
Press the
selection. This port number selects which of the output ports is used to be used for
the hardwired connection between the Remote Receiver and theIris+ Receiver.
Press the
keys to scroll through the menu, until
Press the
Remote Receivers are connected to. Press the
Use the
highlighted.
Press the
now be viewed. Use the
Remote Receivers are online. A typical display is shown in Figure 5.
Press the
to scroll through the menu, until
Press the
The two relevant indicators for the monitoring of the RS485 Bus are described below:
MAS xxx
The number of polls per second ,
from the Iris+ Receiver.
Txx - dd
xx is the number of Bus Master
Timeouts that have occurred and
dd is the last device to time out.
©2018 EMS Ltd. All rights reserved.
1
key, to change the Master Port to 1, then press the
3
key once to return to the Serial Comms menu. Use the
1
key, to select. This will initialise and restart the data bus that the
&
keys to scroll through the menu, until
1
key, to select. The Remote Receivers connected to the system can
key to scroll through the display to check that the
03/Remote
Receiver, ONLINE
(0,00)
2=Help
3
key once to return to the Serial Comms menu. Use the
1
key, to select. A typical display is shown in Figure 6.
HEAP 00 AUX=00 PGR=00
REM 000 MAS 000 T00-00
I 00 L 00
Push Any Key
>Restart Bus<
3
14:29
Figure 5
>Monitor Comms<
R 00 S 00 C 00
14:29
Figure 6
If there is one Remote Receiver
communicating on the RS485 Bus,
the gure will be 10. If there are two
Remote Receivers communicating
on the RS485 Bus, the gure will be
20 and so on.
A time out is where Comms between
the Iris+ Receiver and the Remote
Receiver is lost momentarily.
Page 8 of 16
is displayed.
key when 'done' is shown.
>Device Table<
'Where '03' is the Remote
Receivers NUA code number.
is displayed.
MK108 Iss4 27/07/2018 AJM
key to con rm
&
is
&
keys
Advertisement
Table of Contents
