Table of Contents
Advertisement
Intimate testing of the system which requires the mapping of coverage areas for each Remote
Receiver is achievable. This will require the disconnecting of the aerial connector for all other
receivers than the one to be tested. Then return to the 'On-Site Range Testing' section on page
10, and plot the readings for the individual receiver.
This will need to be repeated for each receiver in turn until a full coverage map is formed. It is
recommended that areas of coverage overlap as shown in the example below.
Iris+
Receiver
Remote
Receiver
Remote
Receiver
Commissioning & Programming
The Iris+ Receiver is pre-con gured before leaving the factory. A computer print out is
included with the equipment, showing the setup of the system. Should it be necessary to
alter the setup, consult the programming guide for details on how to reprogram the Iris+
Receiver.
©2018 EMS Ltd. All rights reserved.
Page 13 of 16
Area
Covered
Remote
Receiver
MK108 Iss4 27/07/2018 AJM
Advertisement
Table of Contents
