Table of Contents
Advertisement
Having installed the Iris+ Receiver and Remote Receivers, it is necessary to programme the
Iris+ Receiver to communicate with the Remote Receivers. If the Iris+ Receiver and the
Remote Receivers were supplied as a system, they will be pre-programmed. If however the
Remote Receiver has been ordered and supplied separately, then the system will need to be
con gured. This con guration should always be checked (see below).
Software Con guration
To allow the Iris+ Receiver to communicate with the Remote Receivers, the Iris+ will have to
be programmed to re-scan it's RS485 Bus. This action will locate all Remote Receivers on the
Bus by identifying their code numbers and allow data received my each Remote Receiver to
be passed to the Iris+ Receiver. If the Iris+ Receiver and Remote Receivers have been supplied
as a system, then the Iris+ Receiver will have these functions pro-programmed. It is good
practice to check that the settings are correct.
The relevant menu options are highlighted below in Figure 2. The programming
requirements are shown in a step by step format in the following sections.
Iris+ Main Menu
The Main Menu can be scrolled through using the
the Iris+ Receiver.
©2018 EMS Ltd. All rights reserved.
Main Menu
Pins & Access
System Support
Serial Comms
Txer Setup
Engineers Ctrl
Time & Date
Radio Setup
Output Setup
Logging
Relay Setup
Remote Rxers
Direct Inputs
Time Control
Txer Grouping
Figure 2
Page 6 of 16
&
keys on the front keypad of
MK108 Iss4 27/07/2018 AJM
Advertisement
Table of Contents
