HDL -MP8B-RF.18 User Manual page 8

User Manual
HDL-MP8B-RF.18
3- Long press any button of panel about 25s (at the 15s, the LED will flash quickly that
means it enters the address modify mode), the LED will flash slowly.
4- Click the 'Search' button, this panel will be shown .
5- Select the module, you will be able to change its ID and remark it. (the Subnet ID must
be same as the gateway's).
6- Click 'Modify Settings of Selection', and it will show 'configurate successful', then all its
wireless parameters will follow the gateway's (Band, Frequency and PSK).
7- Click 'all Node Exit Setup', then the wireless devices will exit the wireless setup mode.
8- Go to the HDL BUS setup tool's main interface to search and add the multi-function
wireless panel, then can start to configure it via the gateway.
5
Multifunctional Wireless Panel – User Manual