Table of Contents
Advertisement
User Manual
HDL-MP8B-RF.18
Wall box: For convenience of the wiring installation, the wall box should be a little deeper
than the power interface.
5. Change the button labels
1.Open the plastic (shown as above) 2. Remove it (take out the label if it is inside)
3. Put the new label in the middle place 4. Put one side of plastic to the button
5. Press the other side of plastic to the button
6. Finish to change the button label
Notes: Label dimension is 31.5mm X 14.5mm, user can use same way to change each
button label.
6. Software Configuration
6.1 Basic Information
6.1.1 Wireless Setting via Mesh Gateway
Before user can configure the wireless panel normally, need to set the wireless
parameters for it via mesh gateway, and the mesh gateway needs to work in mesh mode.
1- Set the free frequency and unique PSK PWD for the gateway
2- Press the 'PROG' button 3 times continuously, the red LED will flash quickly that means
the gateway enters the wireless setup mode.
4
Multifunctional Wireless Panel – User Manual
Advertisement
Table of Contents
