Technical Description - Danmeter CSM 2 User Manual

15

Technical description

Guidance and manufacturer's declaration — electromagnetic emissions
The Cerebral State Monitor CSM is intended for use in the electromagnetic environment specified below. The
customer or the user of the CSM should assure that it is used in such an environment.
Emissions test
RF emission
CISPR 11
RF emission
CISPR 11
Harmonic emission
IEC / EN 61000-3-2
Voltage fluctuations/
flicker emissions
IEC / EN 61000-3-3
Guidance and manufacturer's declaration — electromagnetic immunity
The CSM is intended for use in the electromagnetic environment specified below. The customer or the user
of the CSM should assure that it is used in such an environment,
Immunity test
Electrostatic
discharge (ESD)
IEC / EN 61000-4-2
Electrical fast
transient/burst
IEC / EN 61000-4-4
Surge
IEC / EN 61000-4-5
Cerebral State Monitor - CSM DFU
Compliance
Group 1
Class B
Not Applicable
Not Applicable
IEC / EN 60601 Compliance level
test level
±6 kV contact ±6 kV contact
±8 kV air ±8 kV air
±2 kV for power Not Applicable
supply lines
±1 kV for
input/output lines
±1 kV differential Not Applicable
mode
Electromagnetic environment —
guidance
The Cerebral State Monitor CSM uses
RF energy only for its internal function.
Therefore, its RF emissions are very
low and are not likely to cause any
interference in nearby electronic
equipment.
The Cerebral State Monitor CSM is
suitable for use in all establishments,
including domestic establishments and
those directly connected to the public
low-voltage power supply network that
supplies buildings used for domestic
purposes.
Electromagnetic
environment –
guidance
Floors should be
wood, concrete or
ceramic tile. If floors
are covered with
synthetic material, the
relative humidity
should be at least
30%.
Mains power quality
should be that of a
typical commercial or
hospital environment.
Mains power quality
should be that of a
t i l
Page 30
i l