Test Label Printing - SATO MB200i Service Manual

Unit 6: Troubleshooting

TEST LABEL PRINTING

The test label is designed to assist in the identification of print problems. Follow the flow chart
provided below to perform this activity.
Refer to Figure 1-1 of the Introduction unit in this manual for dipswitch location.
SATO MB2i Service Manual
Choose Applicable Option
RS232C: (DSW = 1: OFF, 2: OFF, 3: OFF, 4: OFF) + FEED + POWER
Wireless LAN: (DSW = 1: OFF, 2: ON, 3: OFF, 4: OFF) + FEED + POWER
Bluetooth: (DSW = 1: OFF, 2: ON, 3: OFF, 4: OFF) + FEED + POWER
Infrared: (DSW = 1: ON, 2: OFF, 3: OFF, 4: OFF) + FEED + POWER
Flashes
orange and enters the
Test Print Mode. Blinks green
while waiting.
Test printing begins.
Flashes green.
Pause printing.
Confirm printing has
stopped and press
POWER.
Printer shuts down.
Figure 6-2, Test Print Mode
PN 9001145B
FEED
FEED
Page 6-6