Grizzly G7944 Owner's Manual page 25

19. Suspend a plumb bob from center of
headstock spindle so it is over tape/ruler as
shown in Figure 19.
20. Center headstock
as indicated by plumb bob and ruler
(see Figure 19).
Figure 19. Aligning headstock with base.
21. Tighten (2) headstock set screws to column,
as shown in Figure 20.
Figure 20. Securing headstock to column.
Model G7943/G7944 (Mfd. Since 09/17)
directly over base
22. To install chuck guard, place chuck guard
over flange of depth gauge mount, as shown
in Figure 21, then tighten Phillips head screw
and hex nut to secure it.
Note: To prevent the guard from slipping off,
move the table up to support it. Or, have an
assistant hold the guard in place while you
secure it.
Figure 21. Installing chuck guard assembly.
23. Thread handles into spindle hub, as shown in
Figure 22, and tighten.
24. Remove screw that fastens belt cover in
place and replace with belt cover knob (see
Figure 22 for location).
Spindle
Hub
Figure 22. Downfeed handles and belt cover
knob installed.
Depth Gauge
Mount
Belt Cover
Knob
-23-