Apm Configuration; Network Stack Configuration; Hdd/Ssd Smart Information; Nvme Configuration - Asus rog crosshair vii hero Manual

3.6.6

APM Configuration

The items in this menu allow you to set system wake and sleep settings.
ErP Ready [Disabled]
This item allows you to switch off some power at S4+S5 or S5 to get the system ready for
ErP requirement. When set to [Enabled], all other PME options are switched off.
Configuration options: [Disabled] [Enable(S4+S5)] [Enable(S5)]
Restore On AC Power Loss
This item allows your system to go to ON state, OFF state, or both states after an AC power
loss. When setting your system to [Last State], it goes to the previous state before the AC
power loss.
Configuration options: [Power Off] [Power On] [Last State]
Power On By PCI-E/PCI
This item allows you to enable or disable the Wake-on-LAN function of the onboard LAN
controller or other installed PCI-E LAN cards.
Configuration options: [Disabled] [Enabled]
Power On By RTC
This item allows you to enable or disable the RTC (Real-Time Clock) to generate a wake
event and configure the RTC alarm date. When enabled, you can set the days, hours,
minutes, or seconds to schedule an RTC alarm date.
Configuration options: [Disabled] [Enabled]
3.6.7

Network Stack Configuration

The items in this menu allow you to enable or disable the UEFI network stack
3.6.8

HDD/SSD SMART Information

This menu displays the SMART information of the connected devices.
NVM Express devices do not support SMART information.
3.6.9

NVMe Configuration

You may view the NVMe controller and Drive information if an NVMe device is connected.
3-18
Chapter 3: BIOS Setup