Asus rog crosshair vii hero Manual page 36

Header
CPU_FAN
CPU_OPT
CHA_FAN1
CHA_FAN2
CHA_FAN3
HAMP_FAN
AIO_PUMP
W_PUMP+
9. ATX power connectors (24-pin EATXPWR; 8-pin EATX12V_1; 4-pin EATX12V_2)
These connectors are for ATX power supply plugs. The power supply plugs are
designed to fit these connectors in only one orientation. Find the proper orientation and
push down firmly until the connectors completely fit.
•
•
•
•
1-20
Max. Current Max. Power
1A
1A
1A
1A
1A
3A
1A
3A
For a fully configured system, we recommend that you use a power supply unit
(PSU) that complies with ATX 12 V Specification 2.0 (or later version) and provides a
minimum power of 350 W.
Do not forget to connect the 4-pin/8-pin EATX12 V power plug. Otherwise, the system
will not boot.
We recommend that you use a PSU with a higher power output when configuring a
system with more power-consuming devices. The system may become unstable or
may not boot up if the power is inadequate.
If you want to use two or more high-end PCIe x16 cards, use a PSU with 1000W
power or above to ensure the system stability.
Default Speed
12W Q-Fan Controlled
12W Q-Fan Controlled
12W Q-Fan Controlled
12W Q-Fan Controlled
12W Q-Fan Controlled
36W Q-Fan Controlled
12W Full Speed
36W Full Speed
Chapter 1: Product Introduction
Shared Control
A
A
-
-
-
-
B
B