Setting The Data Transmission Format - Denso HC36IITK-A Operation Manual

6.3 Setting the Data Transmission Format

In the following format, data will be transmitted:
Header Code mark
If you specify that the code mark follows bar code data, then data will
be transmitted in the following format:
Number of digits
Header
n1
You may choose whether or not to transmit the code mark and the
number of digits, as well as choosing the data transmission format of
the header, terminator, and bar code data by using bar-coded
parameter menus.
In addition, you may define an arbitrary header and terminator from
the ASCII character set (00h to 7Fh) and some control codes keyed in,
as described in Section 6.6.
The default transmission format is shown below.
Terminator
Bar code data
(ENTER)
Code Mark
Bar code type
UPC-A
UPC-E
EAN-13
EAN-8
Standard 2 of 5
Interleaved 2 of 5
Code marks for UPC/EAN with supplemental codes are the same as
those for the corresponding UPC and EAN codes.
Number of digits
Bar code data
n1 n2
Bar code data Code mark
n2
Code
Bar code type
mark
A Codabar
C E Code 39
A F Code 93
B FF Code 128
H EAN-128
I Z
14
Terminator
Terminator
Code
mark
N X
C M Y
L
K
W