Arctic Cat ZR 200 Operator's Manual page 21

2. Remove the bulb from the housing
by rotating it counterclockwise until
loose.
CAUTION
Do not touch the glass portion of the
bulb. If the glass portion is touched, it
must be cleaned with a dry cloth
before installing.
3. Install the new bulb into the hous-
ing; then rotate the bulb clockwise to
lock it into place.
Adjusting Headlight Aim
The headlight can be adjusted for vertical
aim of the HIGH/LOW beam. The geo-
metric center of HIGH beam zone is to be
used for vertical aiming.
1. Position the snowmobile on a level
floor so the headlight is approxi-
mately 8 m (25 ft) from an aiming
surface (wall or similar surface).

NOTE: There should be an "aver-
age" operating load on the snowmo-
bile when adjusting headlight aim.
2. Measure the distance from the floor
to midpoint of the headlight.
3. Using the measurement obtained in
step 2, make a horizontal mark on
the aiming surface.
4. Make a vertical mark which inter-
sects the horizontal mark on the aim-
ing surface directly in front of the
headlight.
5. Engage the brake lever lock and start
the engine. Move the headlight dim-
mer switch to the HIGH beam posi-
tion. DO NOT USE LOW BEAM.
6. Observe the headlight beam aim.
Proper aim is when the most intense
beam is centered on the vertical
mark 50 mm (2 in.) below the hori-
zontal mark on the aiming surface.
7. Adjust the headlight using the screw
on the backside of the headlight until
correct aim is obtained. Shut the
engine off; then disengage the brake
lever lock.
ZR-092A
YM213A
19