Toshiba T4900CT Manual page 131

9. Carefully disconnect the FPC from the HDD pack. Use a thin object to pry each
side of the FPC connector a little at a time to avoid bending the pins, then grasp
the connector and pull it off (figure 4-10).
Installing the HDD
To install the T4900CT's HDD, follow the steps below and refer to figures 4-7 through 4-10.
1. Connect the FPC connector to the HDD and seat the HDD into the bottom half of
the case (figures 4-9 and 4-10).
2. Align the screw holes in the HDD and case, then secure the HDD with two flat-
head screws at the end opposite the FPC connector (figure 4-9).
3. Fit the plastic tab into slots on the bottom half of the case and seat the HDD pack
cover into the case (figure 4-7).
4. Close the case and secure the remaining two flat-head screws.
5. Apply a new VOID seal to the HDD pack.
6. Seat the HDD pack in the computer and secure one M2.5x4 screw (figure 4-8).
7. Fit the tabs on the HDD pack cover into notches on the computer and rotate the
cover into place. Secure the cover with two M2.5x30 screws (figure 4-7).
8. Install the battery pack as described in section 4.2.
4-12
Figure 4-10 Removing the HDD
T4900CT