Panasonic TY-WK98PV1 Installation Instructions Manual page 4

Wall-hanging bracket vertical mounting type, commercial use
Table of Contents

Advertisement

Safety Precautions (continued)
CAUTION:
Do not use any television and displays other than those given in the catalogue.
Do not install it in any other way.
z The display unit may drop, and may cause damage and injury.
Do not install facing upwards, downwards, sideways or upside-down.
z This may cause heat to build up inside the display unit, and may cause a fire.
z The display unit may drop, and may cause damage and injury.
Do not install in any location subject to humidity, dust, smoke, steam or heat.
z This may have an adverse effect on the display and cause fire or electric shock.
Do not block the ventilation holes.
When using the wall-hanging bracket, do not block the space between the rear surface of the display
and the mount surface.
z Otherwise heat may build up inside and cause a fire.
Provide space of at least 10 cm (3.9 inches) above, below, and to the sides of the display unit's
outermost surfaces, and at the rear provide space between the mounting surface and the bracket
mount surface.
z Failing to do so may result in a fire.
Install the mounting screws and power cord in such a way that they will not make contact with the
metal objects behind the wall.
z Electric shocks may result from contact with any metal objects inside the wall.
During installation, provide space to enable tightening of the lock screw and then tighten it.
z Otherwise, the display unit may drop, and may cause damage and injury.
For installation, use the special-purpose components.
z Otherwise, the display unit may drop, and may cause damage and injury.
When removing the display unit, also remove the wall-hanging bracket.
z Otherwise, somebody may, for example, bump into the wall-hanging bracket, and may cause injury.
Remove the product from the installation location when it is no longer going to be used.
z Otherwise, the product may topple over, and may cause damage and injury.
The display unit should be attached and removed by two persons if 25 kg (55.12 lbs) or heavier and by
four persons if 50 kg (110.23 lbs) or heavier. [Follow the instruction manual of the display unit.]
z Otherwise, the display unit may drop, and may cause injury.
Be careful not to have your fingers pinched during installation work.
z It can cause injuries.
Requests regarding handling
1) Exercise care when selecting the location for the display because it may discolor or deform due to light or
heat if it is placed where it is exposed to direct sunlight, or near a heater.
2) Clean the wall-hanging bracket by wiping it with a soft, dry cloth (such as cotton or flannel). If the bracket is
very dirty, remove the dirt using a neutral detergent diluted in water, and then wipe it clean with a dry cloth.
Do not use benzene, thinner, or furniture wax as this may cause the coating to peel.
(For information on cleaning the display unit, see the instruction manual of the display unit.
If using a chemically treated cloth, follow the instructions supplied with the cloth.)
3) Do not affix adhesive tape or stickers to the product. Doing so may dirty the surface of the wall-hanging
bracket.
Do not allow long-term contact with rubber, vinyl products or the like. (Doing so will cause deterioration.)
4) Take care during installation as shocks can cause 'panel cracks' to the display unit.
4 - ENGLISH

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents