Assembling The Set Mounts To Be Attached To The Display Unit - Panasonic TY-WK98PV1 Installation Instructions Manual

Assembling the Bracket to Match the Display Unit Installation Pitch (continued)

Assembling the Set Mounts to Be Attached to the Display Unit

Attention
z Never remove the black countersunk screws at the positions in the "Positions of black countersunk screws"
figure.
The display unit may drop, and may cause damage and injury.
Positions of black countersunk screws
Set mount (Upper)
B-1
Set mount (Upper)
B-1
A
600/800
B
Set mount (Lower)
B-2
16 - ENGLISH
400
500
Set mount (Upper)
B-1
Set mount (Lower)
B-2
1) Assemble the set mounts for the display unit.
A Confirm the positions of the  holes in the set
mount (upper).
z The installation positions differ depending on
B Place the set mount (lower) over the set mount
(upper) and fix it in place with two countersunk
screws.
(Tightening torque: 1.4 to 1.6 N•m)
Attention
z Place the set mount (lower) so that the bottom half
of the  holes in the set mount (upper) are hidden
as shown in the "Position to attach the set mounts
(lower)" (page 17) figure.
z Tighten all countersunk screws so that they are not
higher than the set mount.
If any screw is protruding, the display unit will be
damaged.
the display unit installation pitch.