Assembling The Bracket To Be Attached To The Wall Surface - Panasonic TY-WK98PV1 Installation Instructions Manual

Assembling the Bracket to Match the Display Unit Installation Pitch (continued)

Assembling the Bracket to Be Attached to the Wall Surface

Attention
z The left and right base plates need to be reversed to screw in the screws from the back (surface contacting the wall).
Accordingly, perform the work with the right base plates placed on the left side and left base plates placed on the
right side.
When bracket to be attached to the wall surface
Back (surface contacting the wall)
Countersink
z The surfaces for installing the screws have countersinks so that the countersunk screws sit flush with the surface.
Install the countersunk screws from the surfaces with the countersinks.
z The surfaces with the countersunk screw heads will contact the display unit or wall. Installation will not be
possible if the countersunk screws are protruding so tighten the countersunk screws until their heads are not
higher than the bracket.
z When assembling the bracket, place the plates so that the projections near the screw holes fit into the round holes.
The screws cannot be screwed in if the projections are not fitted into the round holes because the screw holes
will be misaligned.
Round holes Screw hole
Projections
ENGLISH - 13