Vacmaster VOM205P Operator's Manual page 7

6. Your vacuum comes ready for dry vacuum cleaning. For installation instructions, see page 12.
7. For wet vacuum cleaning, install the supplied foam wet filter. (fig. 7) For installation
instructions, see page 12.
8. Place the power head back on the collection tank, and secure into place using the 2 side
latches. (fig. 8 & 9)
9. Insert the larger end of the hose into the desired port. (fig. 10)
10. Choose the desired accessories and insert onto the end of the hose. (fig. 11)
For your convenience this vacuum comes with a wall mounting support for storage.
IMPORTANT!
• Do not mount the rack over 5 feet from the floor.
• Do not screw the rack to drywall only. Secure the screws to a stud.
• Do not hang from or sit on the vacuum when on mounting rack.
• Do not use the vacuum while it is mounted on the wall mounting support.
• Empty the tank before mounting the vacuum on the wall.
11. Make sure the rack is level and mark the hole locations. Make1/8-inch diameter pilot hole in
each marked location. Align the two screw holes so that they are over a stud and secure the
mounting support to the wall stud with the two screws provided. (fig. 12)
12. Place the wet and dry vacuum cleaner into the support. (fig. 13)
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade wider than the
other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet.
Do not change the plug in any way. Double insulation
grounded power cord and grounded power supply system.
eliminates the need for the three wire
7