Connecting To Computer - Sanyo PLC-XW20 Owner's Manual

CONNECTING PROJECTOR
Cables used for connection
• VGA Cable (HDB 15 pin)
• Control Cable for PS/2 Port , Serial Port
• USB Cable ✽
IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA)
Desktop type
COMPUTER IN ANALOG
NOTE :
When connecting the cable, the power
cords of both the projector and the external
equipment should be disconnected from
AC outlet.
peripheral equipment on before the
computer is switched on.
N MAC ADAPTER (Not supplied)
Set switches as shown in the table
below depending on RESOLUTION
MODE that you want to use before
you turn on projector and computer.
13" MODE (640 x 480)
16" MODE (832 x 624)
19" MODE (1024 x 768)
21" MODE (1152 x 870)
12

CONNECTING TO COMPUTER

(✽ = Cable or adapter is not supplied with this projector.)
✽
, or ADB Port
Monitor Output Audio Output
MAC Adapter ✽
Set slide switches
according to the
chart below.
Audio
Cable
✽
(stereo)
VGA Cable
COMPUTER AUDIO IN
Turn the projector and
ON
ON DIP
1 2 3 4 5 6
OFF
1 2 3 4 5 6
ON ON OFF OFF OFF OFF
OFF ON OFF ON OFF OFF
OFF ON ON OFF OFF OFF
ON ON ON ON OFF OFF
• MAC Adapter (When connecting to Macintosh computer)
✽
• Audio Cable (Mini Plug (stereo) x 1)
Laptop type
Serial port PS/2 port
USB port
Control Cable
Control Cable
for Serial Port ✽
USB
for PS/2 Port
Cable ✽
Terminal
Terminal
USB
CONTROL PORT
VIDEO
Y – Pb / Cb – Pr / Cr
RESET
USB
CONTROL PORT S–VIDEO
COMPUTER
AUDIO IN
AV
COMPUTER IN
AUDIO OUT
AUDIO OUT
Audio Cable
(stereo) ✽
Audio Input
External Audio Equipment
Audio Amplifier
✽
ADB port
Control Cable
for ADB Port ✽
Terminal
Use one of these Control Cables
or USB Cable corresponding
with the terminal of your
computer to control the computer
with the Remote Control Unit.
Terminals
of the Projector
Audio Speaker
(stereo)
✽