Connecting The Projector; Terminals Of The Projector - Sanyo PLC-XW15 Owner's Manual

CONNECTING THE PROJECTOR

VIDEO INPUT JACKS
(VIDEO/Y, Pb/Cb, Pr/Cr)
Connect the composite video
output from the video equipment
to the VIDEO/Y jack or connect
the component video outputs to
the Y/VIDEO, Pb/Cb and Pr/Cr
jacks. (Refer to P12.)
RESET BUTTON
This projector uses a micro
processor to control the unit.
Occasionally, the
processor may malfunction and
need to be reset. This can be
done by pressing the RESET
button with a pen, which will
shut down and restart the unit.
Do not use the RESET function
excessively.
AUDIO OUTPUT JACK (STEREO)
Connect an external audio
amplifier to this terminal.
(Refer to P12, 13.)
COMPUTER INPUT TERMINAL
Terminal : HDB15-PIN
Connect the display output terminal of the computer to
COMPUTER INPUT terminal of this projector with the
VGA Cable (supplied).
Macintosh computer, the MAC Adapter (not supplied)
is required.
Pin Configuration
1 Red Input
2 Green Input
3 Blue Input
4 Sense 2
5 Ground (Horiz.sync.)
6 Ground (Red)
7 Ground (Green)
8 Ground (Blue)

TERMINALS OF THE PROJECTOR

VIDEO
Y – Pb/Cb – Pr/Cr
RESET
COMPUTER IN
micro
COMPUTER INPUT TERMINAL
Connect the computer output to
this terminal.
(Refer to P13.)
When connecting the
4 3 2 1
5
10
9 8 7 6
15 14 13 12 11
9 No Connect
10 Ground (Vert.sync.)
11 Sense 0
12 Sense 1
13 Horiz. sync.
14 Vert. sync.
15 Reserved
S – VIDEO
AV
AUDIO OUT
COMPUTER
AUDIO
IN
CONTROL PORT
CONTROL PORT CONNECTOR
Terminal : DIN 8-PIN
Connect control port (PS/2, Serial or ADB port) on your
computer to this terminal with the Control Cable (the Control
Cable for PS/2 port is supplied).
Pin Configuration
1
2
3
4
5
6
7
8
S-VIDEO INPUT JACK
Connect the S-VIDEO output
from the video equipment to this
terminal. (Refer to P12.)
AUDIO INPUT JACK
Connect the audio output from
the video equipment to this
terminal. (Refer to P12.)
COMPUTER AUDIO INPUT JACK
Connect the audio output from
the computer to this terminal.
(Refer to P13.)
CONTROL PORT CONNECTOR
When controlling the computer with
the Remote Control of this projector,
connect the mouse port of your
personal computer to this terminal.
(Refer to P13.)
8 7 6
5 3
4
1
2
PS/2 Serial ADB
----- R X D -----
CLK ----- ADB
DATA ----- -----
GND GND GND
----- RTS -----
----- T X D -----
GND GND -----
----- GND GND
11