Cleaning The Filters; Resetting The Filter Counter - Sanyo PLC-XU305K Owner's Manual

Maintenance and Cleaning

Cleaning the Filters

Filter prevents dust from accumulating on the optical elements inside the projector. Should the filters become
clogged with dust particles, it will reduce cooling fans' effectiveness and may result in internal heat buildup
and adversely affect the life of the projector. If a Filter warning icon appears on the screen, clean the filters
immediately. Clean the filters by following the steps below.
Turn off the projector, and unplug the AC power cord
1
from the AC outlet.
Turn the projector over and remove the filters.

Clean the filters softly by using a brush.
3
Replace the filters properly. Make sure that the filters
4
are fully inserted to the projector.
CAUTION
Do not operate the projector with the filters
removed. Dust may accumulate on the optical
elements degrading picture quality.
Do not put anything into the air vents. Doing so
may result in malfunction of the projector.
RECOMMENDATION
we recommend avoiding dusty/smoky environments
when you operate the projector . Usage in these
environments may cause poor image quality .
When using the projector under dusty or smoky conditions,
dust may accumulate on a lens, LCD panels, or optical
elements inside the projector degrading the quality of a
projected image. When the symptoms above are noticed,
contact your authorized dealer or service station for proper
cleaning.

Resetting the Filter Counter

Be sure to reset the Filter counter after cleaning or replacing
the filters.
Press the MENU button to display the On-Screen
1
Menu. Use the Point
then press the Point
Use the Point
▲▼

and then press the SELECT button. Use the Point
buttons to select Filter counter reset and then
▲▼
press SELECT button. Filter counter Reset? appears.
Select yes to continue.
Another confirmation dialog box appears, select yes to
3
reset the Filter counter.
6
buttons to select Setting and
▲▼
button.
► or SELECT
buttons to select Filter counter
Filters
Filter counter
Note:
When reinserting this
filter, be sure that the
slit part is facing the
outer side.
H
Filter counter , Reset?
appears.
Select yes, then another
confirmation box appears.
Select yes again to reset
the Filter counter.