Connecting To Computer - Sanyo plc-xu33 Owner's Manual

CONNECTING PROJECTOR
Cables used for connection
• VGA Cable (HDB 15 pin)
• Control Cable for PS/2 Port
• DVI-Digital Cable (for Single Link T.M.D.S.)
• Control Cable for Serial Port
IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA)
MAC Adapter ✽
Set slide switches
according to the
chart below.
VGA Cable
DVI/VGA
Adapter
COMPUTER IN DVI-I
NOTE :
When connecting the cable, the power
cords of both the projector and the external
equipment should be disconnected from
AC outlet.
peripheral equipment on before the
computer is switched on.
N MAC ADAPTER (Not supplied)
Set switches as shown in the table
below depending on RESOLU-
TION MODE that you want to use
before you turn on projector and
computer.
13" MODE (640 x 480)
16" MODE (832 x 624)
19" MODE (1024 x 768)
21" MODE (1152 x 870)
12

CONNECTING TO COMPUTER

(✽ = Cable or adapter is not supplied with this projector.)
✽
✽ , or ADB Port ✽
Monitor Output Monitor Input
VGA
Cable ✽
DVI Cable ✽
COMPUTER IN DVI-I MONITOR OUT
COMPUTER IN
DVI - I
R – AUDIO IN – L
S – VIDEO
MCI / WI
Turn the projector and
ON
ON
1 2 3 4 5 6
OFF
1 2 3 4 5
ON ON OFF OFF OFF OFF
OFF ON OFF ON OFF OFF
OFF ON ON OFF OFF OFF
ON ON ON ON OFF OFF
• USB Cable ✽
• MAC Adapter (When connecting to Macintosh computer)
• DVI/VGA Adapter
• Audio Cables (RCA x 2 and Mini Plug (stereo) x 1)
Desktop type
Audio Output USB port
Audio USB
Cable ✽ Cable ✽
(stereo)
AUDIO IN COMPUTER USB
VIDEO
Y – Pb / Cb – Pr / Cr
(MONO)
AUDIO IN
R – AUDIO OUT – L
COMPUTER
RESET
MONITOR OUT
USB CONTROL PORT
AUDIO OUT
Audio Input
DIP
External Audio Equipment
6
Audio Amplifier
Laptop type
Serial port PS/2 port ADB port
Control Cable Control Cable
Control Cable
for Serial Port ✽ for ADB Port ✽
for PS/2 Port
Terminal Terminal Terminal
Use one of these Control
Cables corresponding with
the terminal of your
computer.
CONTROL PORT
Terminals
of the Projector
Audio Cable
(stereo) ✽
Audio Speaker
(stereo)
✽
✽