Traction Control Settings; To Disable The Traction Control - Triumph Bonneville Bobber 2018 Owner's Handbook Manual

Traction Control Settings

Warning
If the traction control is disabled, the
motorcycle will handle as normal but
without traction
situation accelerating too hard on wet/
slippery road surfaces may cause the
rear wheel to slip, and may result in
loss of motorcycle control and an
accident.
The traction control can be set to one of
the following conditions:
ON Optimal traction control setting
for road use, allows minimal rear
wheel slip.
OFF Traction control is turned OFF.
The TC disabled warning light
will be illuminated (see page 27).
Traction control defaults to ON after the
ignition has been switched OFF and
then switched ON again.
control. In this
General Information

To Disable the Traction Control

To disable the traction control setting:
• Make sure
stationary and in neutral.
• Turn the ignition to the ON position
and put the engine start/stop
switch in the RUN position.
• Press and release the SCROLL
button on the left hand handlebar
switch housing
shown in the display.
• Press and hold the SCROLL button
for more than one second to
change between traction control on
and traction control off.
1. Traction control off display
the motorcycle
until 'ttcOn'
1
is
is
37