Triumph Bonneville Bobber 2018 Owner's Handbook Manual page 124

Cleaning and Storage
• If exposure to salt is unavoidable,
clean your leather product immedi-
ately after each exposure using a
damp cloth then leave the product
to dry naturally at room tempera-
ture.
• Gently clean any minor marks with
a damp cloth then leave the
product to dry naturally at room
temperature.
• Place your leather product in a
fabric bag or cardboard box to
protect it when in storage. Do not
use a plastic bag.
124
Preparation for Storage
Clean and dry
thoroughly.
Fill the fuel tank with the correct grade
of unleaded fuel and add a suitable fuel
stabiliser (if available), following the fuel
stabiliser manufacturer's instructions.
Warning
Petrol is extremely flammable and can
be explosive under certain conditions.
Turn the ignition switch OFF. Do not
smoke. Make sure the area is well
ventilated and free from any source of
flame or sparks; this includes any
appliance with a pilot light.
Remove one of the spark plugs from
each cylinder and put several drops
(5 ml) of engine oil into each cylinder.
Cover the spark plug holes with a piece
of cloth or rag. With the engine stop
switch in the RUN position, push the
starter button for a few seconds to coat
the cylinder walls with oil. Install the
spark plugs, tightening to 12 Nm.
Change the engine oil and filter (see
page 80).
Check and if necessary correct the tyre
pressures (see page 103).
Set the motorcycle on a stand so that
both wheels are raised off the ground.
(If this cannot be done, put boards
under the front and rear wheels to keep
dampness away from the tyres.)
the entire vehicle