Wi-Fi Protected Setup (Wps); Using Wps To Connect To A Network - Epson XP-7100 User Manual

6. Use your computer or wireless device to select the Wi-Fi network name (SSID) displayed on the
LCD screen, then enter the password shown.
7. Press OK when you finish entering your password.
8. Select Close to exit.
You see the
your computer or device, and then print. If you are printing from a computer, make sure you installed
the network software as described on the Start Here sheet.
Note: If you don't see the
name or entered the password incorrectly. Repeat these steps to try again.
Parent topic:

Wi-Fi Protected Setup (WPS)

If your network uses a WPS-enabled wireless router or access point, you can quickly connect your
product to the network using Wi-Fi Protected Setup (WPS).
Note: To check if your router is WPS-enabled, look for a button labeled WPS on your router or access
point. If there is no hardware button, there may be a virtual WPS button in the software for the device.
Check your network product documentation for details.

Using WPS to Connect to a Network

Parent topic:
Using WPS to Connect to a Network
If you have a WPS-enabled wireless router or access point, you can use Wi-Fi Protected Setup (WPS) to
connect your product to the network.
1. Press the
2. Press the
icon on the LCD screen and should be able to connect to your product directly from
icon on the LCD screen, you may have selected the wrong network
Wi-Fi Direct Mode Setup
Wi-Fi or Wired Networking
home icon, if necessary.
icon.
48