Lamp Replacement - Sanyo PLC-XC56 Owner's Manual

Sanyo projector user manual

Hide thumbs Also See for PLC-XC56:

Owner's manual (174 pages)

Dimensional drawing (1 page)

Command list (1 page)

Table Of Contents

Table of Contents

Maintenance and Cleaning

When the projection lamp of the projector reaches its end of

life, the Lamp replacement icon appears on the screen and

LAMP REPLACE indicator lights yellow. Replace the lamp with

a new one promptly. The timing when the LAMP REPLACE

indicator should light is depending on the lamp mode.

Note:

• When Mode 2 is selected in the Lamp life control menu,

if the projection lamp of the projector reaches its end of

life, the lamp replacement icon appears on the screen,

and the projector is turned off automatically after 3 minutes.

• The Lamp replacement icon will not appear when the

Display function is set to Off (p.46), during Freeze (p.25),

or No show (p.26).

CAUTION

Allow a projector to cool for at least 45 minutes

before you open the Lamp Cover. The inside of

the projector can become very hot.

CAUTION

When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be broken.

If replacing the lamp of a projector which has been installed on the ceiling, you should always assume that

the lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove the

lamp cover gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass get

into your eyes or mouth, seek medical advice immediately.

Follow these steps to replace the lamp.

Turn off the projector and disconnect the AC power

cord. Allow the projector to cool for at least 45 minutes.

Loosen the screw with a screwdriver, slide and open

the lamp cover.

Loosen 2 screws of the lamp with a screwdriver and pull

out the lamp upwards vertically by grasping the handle.

Replace the lamp with a new one and tighten the 2 screws

back into position. Make sure that the lamp is set properly.

Replace the lamp cover and tighten the screw.

Connect the AC power cord to the projector and turn

on the projector.

Reset the lamp replacement counter .

See "Resetting the Lamp Counter" on the next page.

ORDER REPLACEMENT LAMP

Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following

information to the dealer.

Model No . of your projector

●

Replacement Lamp Type No .

●