Sanyo PLC-XC56 Owner's Manual page 52

Setting
Lamp control
Lamp control
This function allows you to change brightness of the
screen.
Normal ...... Normal brightness
Eco ............ Lower brightness reduces the lamp
Lamp life control
Select the lamp operation when the total lighting time of a
lamp exceeds the recommended total hours of use.
Mode 1 .............. The lamp can be turned on even after
Mode  .............. The lamp can be turned on even after
Note:
• Lamp mode cannot be changed for a while after turning
on the projector. Lamp needs some time to stabilize
after the power is turned on. Stored lamp mode will be
active after the lamp is stabilized.
• If Mode  has been selected and the projection lamp
exceedes the recommended total hours of use, the
replacement icon will be displayed at the time of power-
on. Then the projector will turn off after 3 minutes.
Lamp replacement icon
• The Lamp replacement icon will not appear when the
Display function is set to Off (p.46), during Freeze
(p.25), or No show (p.26).
5
power consumption and extends the
lamp life.
exceeding the recommended total
hours of use.
exceeding the recommended total
hours of use. But the projector turns off
automatically after 3 minutes.
Lamp life control