Philips Vari-Lite VL440 Service Manual page 57

Step 4. Remove Yoke Filler by removing two 6-32 x 3/16" PPB screws and one 8-32 x 3/8" PPB
SEMS screw mounting tilt stabilizer to yoke filler.
NOTE:
Components removed and exploded for clarity.
Step 5. Remove four 8-32 x 3/8" PFZ screws securing each tilt bearing to yoke.
Step 6. Cut any cable ties to give enough wiring slack to lift head from yoke
Step 7. At Right Tilt Bearing Assembly, disconnect extension spring from stabilizer and pass
stabilizer around wiring and tilt bearing.
NOTE:
Components removed and exploded for clarity.
Step 8. Reassemble following steps in reverse order.
02.96 87.001 0 0
M
AINTENANCE
6-32 x 3/16" PPB Screw (x2)
Yoke Filler
Figure 2-22: Yoke Filler Removal
Figure 2-23: Tilt Stabilizer
P : T S
ROCEDURES ILT TABILIZER
2
R
EMOVAL
Tilt Stabilizer
Extension Spring
39