Adjustment For High Altitude Locations - Blodgett SN-3E Installation Operation & Maintenance

Maintenance

ADJUSTMENT FOR HIGH ALTITUDE LOCATIONS

NOTICE
Disconnect the power supply to the appliance
before cleaning or servicing.
The steamer has been factory set so that when it is ON
and in the READY mode, it will maintain water tempera-
ture in the steam generator tank at approximately 205 de-
grees Fahrenheit (just below water boiling point). Howev-
er, for high altitude locations, an authorized servicer must
adjust the steamer temperature lower. To adjust:
1. Remove side panel and turn control panel power
switch to ON.
2. Open compartment door, and after about 5 minutes,
steam will be seen, entering the cooking compart-
ment.
3. Turn thermostat shaft counterclockwise to lower tem-
perature until steam just ceases to enter cooking
compartment and READY light goes on.
4. Replace side panel.
5. Follow TESTING PROCEDURES in this manual.
MAINTENANCE
12