Advertisement
5495
TRIM RING
Thank you for purchasing the Scosche HA1569 Kit. This kit was manufactured with the highest of quality
standards.
CAUTION:
DISCONNECT YOUR VEHICLE'S NEGATIVE BATTERY TERMINAL BEFORE THE INSTALLA-
TION TO HELP PREVENT ELECTRICAL DAMAGE. WE RECOMMEND THE USE OF A VOLT/
OHM METER OVER A TEST LIGHT TO CHECK WIRING. A TEST LIGHT OR GROUNDED WIRE
PROBE CAN CAUSE DAMAGE TO THE VEHICLE'S COMPUTER AND/OR DIAGNOSTIC
SYSTEMS. AVOID ALL FACTORY AIR BAG WIRING - AIR BAGS CAN ACCIDENTALLY DEPLOY
CAUSING SERIOUS INJURY OR DEATH.
NOTES:
•
See your vehicle's instructions for any special tools your installation might require.
•
Read all instructions accompanying your car stereo/cassette player for proper wiring and mounting
instructions.
This instruction booklet is based on carefully documented data and research of automobile dash
disassembly, wire harness/codes and information pertaining to installation of this kit (CR1284) in
2004 Chrysler Pacifica Vehicles. Scosche Industries, Inc. can not be held responsible for
discrepancies/inconsistencies that may occur due to the automobile manufacturing changes or
options, or damage that may occur in the automobile during the installation of components while
using this booklet.
IN-DASH INSTALLATION KIT FOR
2004 CHRYSLER PACIFICA
INTRODUCTION / PRELIMINARY
LIABILITY DISCLAIMER
5404 POCKET
5464
MOUNTING PANEL
CR1284
5403-1
REAR
SUPPORT
Advertisement
Table of Contents
Related Manuals for Scosche CR1284
Summary of Contents for Scosche CR1284
- Page 1 5464 TRIM RING MOUNTING PANEL INTRODUCTION / PRELIMINARY Thank you for purchasing the Scosche HA1569 Kit. This kit was manufactured with the highest of quality standards. CAUTION: DISCONNECT YOUR VEHICLE'S NEGATIVE BATTERY TERMINAL BEFORE THE INSTALLA- TION TO HELP PREVENT ELECTRICAL DAMAGE. WE RECOMMEND THE USE OF A VOLT/ OHM METER OVER A TEST LIGHT TO CHECK WIRING.
- Page 2 6. Extract four (4) Phillip head screws from radio, disconnect and remove. NOTE: Before mounting the CR1284 Kit Panel to the factory dash, you must custom modify the dash cavity. Located on the bottom area of the dash cavity is a pair of plastic rear supports. You must cut/remove the rear supports to ensure the kit panel’s pocket will not interfere with the dash...
Need help?
Do you have a question about the CR1284 and is the answer not in the manual?
Questions and answers