LabelTac Pro X User Manual page 6

Item
Speed Use this item to setup print speed.
Use this option to setup printing darkness. The available setting is from 0 to 15,
Density
and the step is 1. You may need to adjust your density based on selected media.
The direction setting value is either 1 or 0. Use this item to setup the printout
direction.
Direction
This item is used to set the print mode.
There are 5 modes as below,
Printer Mode
Batch Mode
Print mode
Peeler Mode
Cutter Mode
Cutter Batch
This item is used to fine tune media stop location. Available setting value is from
Offset
"+" to "-" or "0" to "9".
This item is used to fine tune print position. Available setting value is from "0" to "9".
Shift X
Shift Y
This item is used to set the origin of printer coordinate system horizontally and
Reference X
vertically. Available setting value is from "0" to "9".
Reference Y
Code Page
Use this item to set the code page of international character set.
Print mode
Use this option to set the country code.
Note: If printing from enclosed software/driver, the software/driver will send out the commands, which will
overwrite the settings set from the panel.
Description
DIRECTION 0
DIRECTION
None Next label top of form is aligned to the print
head burn line location. (Tear Off Mode)
Once image is printed completely, label gap/
black mark will be fed to the tear plate location
for tear away.
Enable the label peel off mode.
Enable the label cutter mode.
Cut the label once at the end of the printing job.
LabelTac Pro X |
®
DIRECTION 1
Description
REFERENCE GUIDE
Default
N/A
8
0
Batch Mode
+000
+000
+000
000
000
850
001